80 Ton Perforating Press
100 Ton Perforating Press
110 Ton Perforating Press
150 Ton Perforating Press
The equipment listed above is not available at every location. See our Capabilities Sheet to learn more about our equipment and capabilities available at each location.
Panel Processing has more capacity to produce pegboard panels than any other fabricator in North America. Our CNC controlled punch presses can produce clean & sharp pegboard holes with accurate margins on all four sides. Pegboard is produced from hardboard and HDF (High Density Fiberboard).
Standard patterns offered are 1″ x 1″ OC, 1/2″ x 1/2″ OC, 1″ x 2″ OC, and 1″ x 3″ OC. Hole sizes are 9/32″ diameter (nominal 1/4″) and 3/16″ diameter (nominal 1/8″). Our CNC perforators also produce hole patterns with varying spaces between the rows of holes. Peg hole column spacing can be varied through removing punches in our perforating dies. Blank spaces are for logos, graphics or design variations, creating a custom pegboard. Remember you are not limited to standard pegboard patterns with Panel Processing.
Large roll outs are no problem with multiple punch presses in all of our plants. No job is too large, or too small.